[系统] 【请教】x61超频有没有可靠的方案

Posted by jonathanhim on 2010-7-23 01:11
問題來了... 硬改完後想變回原形那該怎做 ?

Posted by qwer20060606 on 2010-7-23 21:16
谢谢keanu59，4g如何全应用起来？

Posted by keanu59 on 2010-7-23 21:55

991474
這2個檔解壓縮後   boot.ini放到 c: 下

mykernel.exe放到C:\WINDOWS\system32

從開機就OK 啦!

Posted by viktor on 2010-7-24 16:57


比较好奇这是什么版本的核心。

Posted by keanu59 on 2010-7-24 17:09

36樓那邊我有PO圖ㄚ!
xp sp3 32位元

Posted by keanu59 on 2010-7-24 17:09

36樓那邊我有PO圖ㄚ!
xp sp3 32位元

Posted by wiseinfo on 2010-7-22 12:27


谁用T9300的试试, 理论是可以上到3.3G

Posted by keanu59 on 2010-7-25 23:40
可以的,拆機......
完成要PO圖喔!

[ Edited by  keanu59 on 2010-7-25 23:43 ]

Posted by neutron1988 on 2010-7-25 23:47

能具体说明一下吗，比如在哪里获取所需的电路图、文档之类的。
刚刚我找了找不到

T60是i945PM芯片组，和x61不一样的

Posted by neutron1988 on 2010-7-25 23:47

能具体说明一下吗，比如在哪里获取所需的电路图、文档之类的。
刚刚我找了找不到

T60是i945PM芯片组，和x61不一样的

Posted by asdlt on 2010-7-26 05:32
945芯片组可以支持200MHz外频。

2.16GHz的T2600外频为166MHz，倍频13x，超到200MHz外频后可以运行在2.6GHz。

具体到PLL操作，就是将FS_A/FS_B/FS_C从1-1-0(166MHz)变为0-1-0(200MHz)，也就是把FS_A断开接 ...

Posted by wombat on 2010-7-26 10:21
前两天试了一次
断PLL后无法开机，目前连上继续用原始频率
过两天另外找根内存再试

Some of you may recall that I did this with a t42p a while back, and now that I have a thinkpad again, I gave it a shot on my old board before I replaced it with a t60p board (wohoo, a dedicated gpu!). I used a 10K pulldown on FSA after removing the 10K pullup, but the laptop failed to post when forced to 200FSB.

Unfortunately, the t60p uses the same clock generator. I don't know if it was a limitation of my components or something else that cause the post failure. The board works as it did before after reverting it back to stock.

ICS954309 is the clock generator and the datasheet is freely available from the ICS site.