intel wifi link 5100无线问题

pu1030

我的本是thinkpad t400, intel wifi link 5100无线网卡，内核 2.6.27，系统 fedora 9 ,但是无线网卡总是有问题：
＃ifup wlan0
Error for wireless request "Set Mode" (8B06) :
    SET failed on device wlan0 ; Invalid argument.
Error for wireless request "Set Encode" (8B2A) :
    SET failed on device wlan0 ; Invalid argument.

正在决定 wlan0 的 IP 信息...

就是网线网卡的指示灯亮了，但无法正常工作，总提示有上面的错误，selinux也报错。。

以下是一些基本信息：

＃iwconfig wlan0
wlan0     IEEE 802.11abgn  ESSID:"TP-LINK"  
          Mode:Managed  Frequency:2.412 GHz  Access Point: Not-Associated   
          Tx-Power=15 dBm   
          Retry min limit:7   RTS thrff   Fragment thr=2352 B   
          Encryption keyff
          Power Managementff
          Link Quality:0  Signal level:0  Noise level:0
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:0   Missed beacon:0

＃lshw -C network
  *-network               
       description: Ethernet interface
       product: 82567LM Gigabit Network Connection
       vendor: Intel Corporation
       physical id: 19
       bus info: pci@0000:00:19.0
       logical name: eth0
       version: 03
       serial: 00:1c:25:96:33:6f
       size: 100MB/s
       capacity: 1GB/s
       width: 32 bits
       clock: 33MHz
       capabilities: pm msi bus_master cap_list ethernet physical tp 10bt 10bt-fd 100bt 100bt-fd 1000bt-fd autonegotiation
       configuration: autonegotiation=on broadcast=yes driver=e1000e driverversion=0.3.3.3-k6 duplex=full firmware=1.8-3 ip=192.168.1.102 latency=0 link=yes module=e1000e multicast=yes port=twisted pair speed=100MB/s
  *-network
       description: Wireless interface
       product: Intel Corporation
       vendor: Intel Corporation
       physical id: 0
       bus info: pci@0000:03:00.0
       logical name: wmaster0
       version: 00
       serial: 00:21:5d:46:52:2c
       width: 64 bits
       clock: 33MHz
       capabilities: pm msi pciexpress bus_master cap_list logical ethernet physical wireless
       configuration: broadcast=yes driver=iwlagn latency=0 module=iwlagn multicast=yes wireless=IEEE 802.11abgn
  *-network DISABLED
       description: Ethernet interface
       physical id: 2
       logical name: pan0
       serial: 92:7c:9e:d6:8e:7d
       capabilities: ethernet physical
       configuration: broadcast=yes driver=bridge driverversion=2.3 firmware=N/A link=yes multicast=yes

＃dmesg

iwlagn: Intel(R) Wireless WiFi Link AGN driver for Linux, 1.3.27kds
iwlagn: Copyright(c) 2003-2008 Intel Corporation
iwlagn 0000:03:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
iwlagn 0000:03:00.0: setting latency timer to 64
iwlagn: Detected Intel Wireless WiFi Link 5100AGN REV=0x54
iwlagn: Tunable channels: 13 802.11bg, 24 802.11a channels
iwlagn 0000:03:00.0: PCI INT A disabled
phy0: Selected rate control algorithm 'iwl-agn-rs'
HDA Intel 0000:00:1b.0: PCI INT B -> GSI 17 (level, low) -> IRQ 17
HDA Intel 0000:00:1b.0: setting latency timer to 64
................
iwlagn 0000:03:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
iwlagn 0000:03:00.0: restoring config space at offset 0x1 (was 0x100102, writing 0x100106)
firmware: requesting iwlwifi-5000-1.ucode
Registered led device: iwl-phy0:radio
Registered led device: iwl-phy0:assoc
Registered led device: iwl-phy0:RX
Registered led device: iwl-phy0:TX
ADDRCONF(NETDEV_UP): wlan0: link is not ready

.........................

iwlagn 0000:03:00.0: PCI INT A disabled
iwlagn 0000:03:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
iwlagn 0000:03:00.0: restoring config space at offset 0x1 (was 0x100102, writing 0x100106)
iwlagn: Error sending REPLY_ADD_STA: time out after 500ms.
Registered led device: iwl-phy0:radio
Registered led device: iwl-phy0:assoc
Registered led device: iwl-phy0:RX
Registered led device: iwl-phy0:TX
ADDRCONF(NETDEV_UP): wlan0: link is not ready


不知哪位达人有解决的经验。。非常感激！！

pei1985

我也有这个问题。现在正用最新驱动测试呢。

pu1030

2.6.27内核下，把selinux禁用，用networkmanager管理就行了
但2.6.25内核下还是不行。